The Mineraluxe Cleanse & Drain is used to remove the accumulation of organic waste and thoroughly clean hot tub piping. It's use is advised before beginning the Mineraluxe System. With less effective systems, contaminants gather, develop (as biofilms), and otherwise accumulate in the circulation system and filter housing. Treatments of this nature are typically no longer required once on the Mineraluxe system.
Mineraluxe Cleanse & Drain Application:
- Maintain hot tub water temperature at 95 F or higher.
- Remove filter cartridge
- Add 750 ml of Mineraluxe Cleanse & Drain to hot tub water
- Run high speed pump for at least 5 minutes, with diverter valves neutral, jets on and air off. It will foam!
- Maintain water temperature and allow hot tub water to circulate through plumbing.
- Run on high speed pump for 5 minutes, 2-3 times over 24 hrs-48 hrs.
- Drain hot tub completely. Rinse and refill hot tub.
- Replace filter cartridge.
- Start up with your Mineraluxe preferred system.
